我的位置：
| 经销商 | 联系方式 | 价格 |
|---|---|---|
| 爱思创Extron电子 | 4000.398766、 021-3760 1568 | 面议 |
| XTP T EU 202 and XTP T MK 202 | |||
|
|||
|
|||
| Video | |||
|---|---|---|---|
| Gain | Unity | ||
| Resolution range | |||
| Digital | Up to 1920x1200*, 2K, or 1080p (HDTV) * reduced blanking |
||
| Analog | Up to 1920x1200* or 1080p (HDTV) * reduced blanking |
||
| Signal type | Single-link HDMI (or DVI-D*) | ||
| Digital video | RGB digital video (DVI and HDMI standards) or Y, Cr, Cb digital component video (HDMI), actively buffered (supports all single-link DVI (if using an optional adapter) and HDMI standards from 640x480 @ 60 Hz to1900x1200 @ 60 Hz) | ||
| EDID and DDC | Supports Extended Display Identification Data (EDID) and Display Data Channel (DDC) data using DVI and HDMI standards. EDID and DDC signals are actively buffered. | ||
| HDCP | Compliant with High-bandwidth Digital Content Protection (HDCP) using DVI and HDMI standards | ||
| HPD | Supports hot plug detection (HPD) of display as a pass-through signal. | ||
| Maximum data rate | 6.75 Gbps (2.25 Gbps per color) | ||
| Maximum pixel clock | 165 MHz | ||
| Formats | RGB and YCbCr digital video | ||
| Standards | DVI 1.0, HDMI, HDCP 1.1 | ||
| Video input | |||
| Number/signal type | 1 analog RGBHV 1single link HDMI (DVI-D or DisplayPort*) input |
||
| Connectors | 1 female 15-pin HD 1female HDMI type A |
||
| Nominal level | 0.7 Vp-p for RGB | ||
| Minimum/maximum levels | 0.3 V to 1.45 V p-p | ||
| Impedance | 75 ohms | ||
| Horizontal frequency | 30 kHz to 100 kHz | ||
| Vertical frequency | 24 Hz to 120 Hz | ||
| Interconnection between transmitter and receiver | |||
| Connectors | 1 female RJ-45 per unit | ||
| Termination standards | TIA/EIA T568B | ||
| Signal transmission distance | 330' (100 m) using shielded twisted pair cable or XTP DTP 24 cable | ||
| Cable requirements | Solid conductor, 24 AWG or better | ||
| Cable recommendations | 400 MHz bandwidth, STP (Shielded Twisted Pair) | ||
|
|||
| Audio | |||
| Gain | |||
| Range | -18 dB to +24 dB | ||
| Default | Unbalanced output: 0 dB; balanced output +6 dB | ||
| Frequency response | 20 Hz to 20 kHz, ±0.05 dB | ||
| THD + Noise | 0.01% @ 1 kHz at nominal level | ||
| S/N | >90 dB, at maximum output, balanced (unweighted) | ||
| Crosstalk | <-45 dB @ 20 kHz, -72 dB @ 1 kHz or below | ||
| Stereo channel separation | >80 dB @ 20 Hz to 20 kHz | ||
| Sampling rates | 32 kHz, 44.1 kHz, 48 kHz, 96 kHz, 192 kHz | ||
| Bit depths | 16, 20, 24 bit | ||
| Audio input | |||
| Number/signal type | 1 analog stereo, unbalanced or 1digital audio, embedded from HDMI |
||
| Connectors | 1 female 3.5 mm mini audio jack 1female HDMI type A (shared with video input) |
||
| Source formats | LPCM up to 7.1/24-bit/192 kHz, Dolby TrueHD, Dolby Digital Plus, Dolby Digital EX, Dolby Digital 5.1, Dolby Digital 2/0 Surround, Dolby Digital 2/0, DTS-HD Master Audio, DTS-HD, DTS-ES Discrete 6.1, DTS-ES Matrix 6.1, DTS Digital Surround 5.1, DTS 2 Channel | ||
| Impedance | >10k ohms, unbalanced, DC coupled | ||
| Nominal level | +4 dBu (1.23 mVrms) balanced or -10 dBV (316 mVrms) unbalanced | ||
| Maximum level | +7 dBv unbalanced | ||
|
|||
| Communications — transmitter | |||
| Serial control port | 1 bidirectional RS-232: 1 rear panel 3.5 mm captive screw connector, 3 pole | ||
| Baud rate and protocol | 9600 (default) to 115200 baud, 8 data bits, 1 stop bit, no parity | ||
| Serial control pin configuration | 1 = Tx, 2 = Rx, 3 = GND | ||
| USB control ports | 1 side panel female mini USB B | ||
| USB standards | USB 2.0, low speed | ||
| Program control | Extron control/configuration program for Windows ® Extron Simple Instruction Set (SIS ™ ) |
||
| Communications — external device (pass-through, unidirectional or bidirectional) | |||
| Serial control port input/output | RS-232 (±5 V) via (1) 3.5 mm, 5 pole captive screw connector (uses 3 poles) (connector is shared with IR control port) | ||
| Serial control port output/input | 1 set of proprietary signals on a female RJ-45 jack | ||
| Baud rates | Up to 115200 baud | ||
| Protocol | Data bits = 5 - 8 Stop bits = 1 or 2 Parity = odd, even, none Flow control = XON, XOFF, none |
||
| Serial control pin configuration | 1 = Tx, 2 = Rx, 3 = GND | ||
| IR control port | (1) 3.5 mm, captive screw connector, 5 pole (connector is shared with RS-232 control port) TTL level (0 to 5 V) modulated infrared control from 30 kHz up to 40 kHz |
||
| IR control pin configuration | 3 = GND, 4 = IR Tx, 5 = IR Rx | ||
| General | |||
| Power supply | External Input: 100 to 240 VAC, 50-60 Hz Output:12 VDC,1.5 A, 18 watts |
||
| Power consumption | |||
| Device | 8.8 watts, 12 VDC | ||
| Device and power supply | 10.7 watts, 100-240 VAC, 50-60 Hz | ||
|
|||
| Temperature/humidity | Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +104 °F (0 to +40 °C) / 10% to 90%, noncondensing |
||
| Cooling | Convection, no vents | ||
| Thermal dissipation | |||
| Device | 29.9 BTU/hr | ||
| Device and power supply | 36.3 BTU/hr | ||
| Mounting | |||
| Furniture or wall mount | Yes, with aEU/MK2-gang electrical junction box | ||
| Enclosure type | Metal | ||
| Enclosure dimensions | |||
| XTP T EU 202 | |||
| Faceplate | 3.2" H x 6.0" W x 0.5" D (2-gang) (8.1 cm H x15.2 cm W x1.4 cm D) |
||
| Device | 1.9" H x 4.3" W x 1.4" D (4.9 cm H x 10.9 cm W x3.5 cm D) (Depth excludes connectors. Fits some EU 2-gang boxes.) |
||
| XTP T MK 202 | |||
| Faceplate | 3.4" H x 5.8" W x 0.5" D (2-gang) (8.6 cm H x14.7 cm W x1.4 cm D) |
||
| Device | 1.9" H x 4.3" W x 1.4" D (4.9 cm H x10.9 cm W x3.5 cm D) (Depth excludes connectors. Fits some MK 2-gang boxes.) |
||
| Product weight | 0.7 lbs (0.3 kg) | ||
| Vibration | ISTA 1A in carton (International Safe Transit Association) | ||
| Regulatory compliance | CE, c-UL, UL, C-tick, FCC Class A, ICES, VCCI Complies with the appropriate requirements of RoHS andWEEE. |
||
| Product warranty | 3 years parts and labor | ||
| Everlast power supply warranty | 7 years parts and labor | ||
|
|||
|
|||
| (4447-D6) | |||
