数字音视工程网

微信公众号

数字音视工程网

手机DAV

null
null
null
null
null
null
null
null
艾索
null
null

我的位置:

爱思创Extron电子-用于地插盒的 2 路输入 XTP 发送器-XTP T FB 202

厂家报价:面议 产品状态:(在产)

用于地插盒的 2 路输入 XTP 发送器 XTP T FB 202

产品品牌: 爱思创EXTRON
产品类别: 产品中心
加入收藏 我要评价 咨询
咨询
姓名:*
手机:*
职位:
邮箱:*
所在单位:*
其他联系方式:
咨询内容:
验证码:
不能为空 验证码错误
确定
爱思创电子(上海)有限公司_爱思创Extron中国

厂商介绍: 爱思创电子(上海)有限公司(爱思创Extron中国)全球总部位于美国加州,是世界领先的专业视音频系统集成产品的生产商。爱思创Extron产品主要包括视音频控制系统、计算机视频接口、切换器、矩阵切换器、分配放大器、音频放大器、扬声器、双绞线和光纤设备、视频图像解析度转换器、视音频信号处理器、视音频流媒... [详细]

经销商 联系方式 价格
爱思创Extron电子 4000.398766、 021-3760 1568 面议
XTP T FB 202
NOTE The XTPswitchercan be used with other Extron XTP products, with twisted pair cables connecting the units.
NOTE *Appropriate DVI-D to HDMI or DisplayPort to HDMI cables or adapters are required for DVI or DisplayPortsignal input.
Video
Gain Unity
Resolution range
Digital Up to 1920x1200*, 2K, or 1080p (HDTV)
* reduced blanking
Analog Up to 1920x1200* or 1080p (HDTV)
* reduced blanking
Signal type Single-link HDMI (or DVI-D*)
Digital video RGB digital video (DVI and HDMI standards) or Y, Cr, Cb digital component video (HDMI), actively buffered (supports all single-link DVI (if using an optional adapter) and HDMI standards from 640x480 @ 60 Hz to1900x1200 @ 60 Hz)
EDID and DDC Supports Extended Display Identification Data (EDID) and Display Data Channel (DDC) data using DVI and HDMI standards. EDID and DDC signals are actively buffered.
HDCP Compliant with High-bandwidth Digital Content Protection (HDCP) using DVI and HDMI standards
HPD Supports hot plug detection (HPD) of display as a pass-through signal.
Maximum data rate 6.75 Gbps (2.25 Gbps per color)
Maximum pixel clock 165 MHz
Formats RGB and YCbCr digital video
Standards DVI 1.0, HDMI, HDCP 1.1
Video input
Number/signal type 1 analog RGBHV
1single link HDMI (DVI-D or DisplayPort*) input
Connectors 1 female 15-pin HD
1female HDMI type A
Nominal level 0.7 Vp-p for RGB
Minimum/maximum levels 0.3 V to 1.45 V p-p
Impedance 75 ohms
Horizontal frequency 30 kHz to 100 kHz
Vertical frequency 24 Hz to 120 Hz
Interconnection between transmitter and receiver
Connectors 1 female RJ-45 per unit
Termination standards TIA/EIA T568B
Signal transmission distance 330' (100 m) using shielded twisted pair or XTP DTP 24 cable
Cable requirements Solid conductor, 24 AWG or better
Cable recommendations 400 MHz bandwidth, STP (Shielded Twisted Pair)
NOTE Extron XTP DTP 24 shielded twisted pair cable is stongly recommended for optimal performance.
Audio
Gain
Range -18 dB to +24 dB
Default Unbalanced output: 0 dB; balanced output +6 dB
Frequency response 20 Hz to 20 kHz, ±0.05 dB
THD + Noise 0.01% @ 1 kHz at nominal level
S/N >90 dB, at maximum output, balanced (unweighted)
Crosstalk <-45 dB @ 20 kHz, -72 dB @ 1 kHz or below
Stereo channel separation >80 dB @ 20 Hz to 20 kHz
Sampling rates 32 kHz, 44.1 kHz, 48 kHz, 96 kHz, 192 kHz
Bit depths 16, 20, 24 bit
Audio input
Number/signal type 1 analog stereo, unbalanced or
1 digital audio, embedded from HDMI
Connectors 1 female 3.5 mm mini audio jack
1 female HDMI type A (shared with video input)
Source formats LPCM up to 7.1/24-bit/192 kHz, Dolby TrueHD, Dolby Digital Plus, Dolby Digital EX, Dolby Digital 5.1, Dolby Digital 2/0 Surround, Dolby Digital 2/0, DTS-HD Master Audio, DTS-HD, DTS-ES Discrete 6.1, DTS-ES Matrix 6.1, DTS Digital Surround 5.1, DTS 2 Channel
Impedance >10k ohms, unbalanced, DC coupled
Nominal level +4 dBu (1.23 mVrms) balanced or -10 dBV (316 mVrms) unbalanced
Maximum level +7 dBv unbalanced
NOTE 0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV≈ 2 dBu
Communications — switcher
Serial control port 1 bidirectional RS-232: 1 rear panel 3.5 mm captive screw connector, 3 pole
Baud rate and protocol 9600 (default) to 115200 baud, 8 data bits, 1 stop bit, no parity
Serial control pin configuration 1 = Tx, 2 = Rx, 3 = GND
USB control ports 1 front panel female mini USB B
USB standards USB 2.0, low speed
Program control Extron control/configuration program for Windows ®
Extron Simple Instruction Set (SIS )
Communications — external device (pass-through, unidirectional or bidirectional)
Serial control port input/output RS-232 (±5 V) via (1) 3.5 mm, 5 pole captive screw connector (uses 3 poles) (connector is shared with IR control port)
Serial control port output/input 1 set of proprietary signals on a female RJ-45 jack
Baud rates Up to 115200 baud
Protocol Data bits = 5 - 8
Stop bits = 1 or 2
Parity = odd, even, none
Flow control = XON, XOFF, none
Serial control pin configuration 1 = Tx, 2 = Rx, 3 = GND
Ethernet pass-through port 1 female RJ-45 connector
Ethernet data rate 10/100Base-T, half/full duplex with autodetect
IR control port (1) 3.5 mm, captive screw connector, 5 pole (connector is shared with RS-232 control port)
TTL level (0 to 5 V) modulated infrared control from 30 kHz up to 40 kHz
IR control pin configuration 3 = GND, 4 = IR Tx, 5 = IR Rx
General
Power supply External
Input: 100 to 240 VAC, 50-60 Hz
Output:12 VDC,1.5 A, 18 watts
Power consumption
Device 10.4 watts, 12 VDC
Device and power supply 12.9 watts, 100-240 VAC, 50-60 Hz
NOTE Each XTP switcher, transmitter, receiver can be powered either locally by an external power supply or remotely using an optional power injector.
Temperature/humidity Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
Operating: +32 to +104 °F (0 to +40 °C) / 10% to 90%, noncondensing
Cooling Convection, no vents
Thermal dissipation
Device 33.1 BTU/hr
Device and power supply 41.8 BTU/hr
Mounting
Floor box mount Ackermann GB3/OBO Betterman floor box, MK Electric CableLink Plus Single Pan floor box, MK Electric CableLink Plus Modular floor box, ElectraPlan floor box, and PUK floor box mountable
NOTE See the XTP T FB 202 User Guide for mounting considerations.
Enclosure type Metal
Enclosure dimensions 2.3" H x 2.8" W x 5.2" D*
(5.9 cm H x 7.2 cm W x 13.2 cm D)
(Dimensions exclude connectors)
* Depth is 6.1" (15.5 cm) including mounting tabs
Product weight 1.4 lbs (0.6 kg)
Shipping weight 4 lbs (2 kg)
Vibration ISTA 1A in carton (International Safe Transit Association)
Regulatory compliance CE**, c-UL, UL, C-tick, FCC Class A**, ICES, VCCI
Complies with the appropriate requirements of RoHS andWEEE.
NOTE **CE and FCC testing is conducted with STP (shielded twisted pair) cable.
Product warranty 3 years parts and labor
Everlast power supply warranty 7 years parts and labor
NOTE All nominal levels are at ±10%.
NOTE Specifications are subject to change without notice.
(4449-D6)
    null